Pass Your Red Seal

Landscape Horticulturist Flashcard Match

Online Red Seal Exam Preparation, built on official standards
Flashcard Match10 pairs · 1 decoyChecked at the endStart matching

Set up a round

Cards from

Pairs per round

Blocks

Decoys

240 cards to draw from

ACommon occupational skills46
BApplies horticultural principles58
CLandscape construction80
DLandscape maintenance56

Your rounds

Kept on this device
Average79%
Best100%

Checking

What a checked pair looks like
Browse the 20 free cards and explanations

A chemical-resistant glove looks intact, but liquid from a spill has entered through its cuff and wetted the inside. What should the worker do before resuming handling?

Answer: Remove it safely, address the skin exposure and replace the contaminated glove.

An intact outer surface does not protect against chemical already inside. Follow the product's exposure and decontamination instructions before putting on clean protection.

Exam trap: Wiping only the outside leaves chemical trapped against the skin.

Standard reference: RSOS 2018 A-1.01.04P

A mower develops strong vibration immediately after blade sharpening. Its mounting is secure, and inspection confirms a straight blade and intact deck. Which check should precede further operation?

Answer: Check the blade's balance using the manufacturer's procedure, with the mower safely isolated.

Removing unequal amounts of metal can unbalance a straight, sharp blade. The timing and verified mounting make balance a priority, without treating tightening as a cure.

Exam trap: A sharp edge and a tight bolt do not establish that the rotating mass is balanced.

Standard reference: RSOS 2018 A-2.02.04P

In job scheduling, what is the critical path?

Answer: The dependent sequence of activities that determines the earliest project completion.

A delay on that sequence delays completion unless the plan is changed. It is determined by dependencies and durations, not by the size of a single crew.

Exam trap: The activity with the most person-hours is not automatically the critical path.

Standard reference: RSOS 2018 A-3.04.01L

An unknown caller asks a landscape office for a client's address and gate code, saying they are a subcontractor. What should staff do before sharing the information?

Answer: Verify the caller's identity and authority through the established project contact process.

Access information should be disclosed only for an authorized purpose. A claimed role is not proof that the person is entitled to it.

Exam trap: Knowing the client's name does not establish permission to receive the gate code.

Standard reference: RSOS 2018 A-4.03.03P

What do stomata and their guard cells regulate in a leaf?

Answer: Gas exchange and the escape of water vapour through the stomatal openings.

Changes in guard-cell condition open or close the pores, influencing carbon dioxide entry and transpiration. The pores are not vessels transporting sap through the plant.

Exam trap: Confusing stomata with xylem mistakes a surface opening for an internal transport tissue.

Standard reference: RSOS 2018 B-6.01.03L

A grower calls an EC rise from 0.8 to 1.6 mS/cm proof of increasing salinity, but the first report used a 1:2 extract and the second a saturated-media extract. What must be resolved first?

Answer: Compare results using compatible extraction methods and units before calling it a salinity trend.

Changing the extraction changes the concentration being measured. The numbers cannot be treated as a direct time comparison without a valid common basis.

Exam trap: Dividing the two reported values does not remove the difference in test methods.

Standard reference: RSOS 2018 B-6.02.06P

A leaf-feeding larva has three pairs of true legs and seven pairs of fleshy abdominal prolegs. Before selecting a caterpillar-specific control, which group should be considered?

Answer: Sawfly larvae, rather than moth or butterfly caterpillars.

Exposed sawfly larvae typically have more abdominal proleg pairs than caterpillars. Accurate identification matters because a control effective on one group may not control the other.

Exam trap: A caterpillar-like body shape alone does not establish that a caterpillar-specific product will work.

Standard reference: RSOS 2018 B-6.04.03P

A compost pile made mostly from fresh grass clippings has compacted into a wet, sour-smelling mass. What process correction is needed?

Answer: Loosen and aerate it, mixing in suitable dry, coarse carbon-rich material to balance the wet clippings.

The dense wet mass restricts oxygen. Structure, moisture balance and a suitable mixture help restore aerobic decomposition.

Exam trap: Adding another thick layer of wet clippings makes the oxygen and moisture imbalance worse.

Standard reference: RSOS 2018 B-7.01.06P

Two soils both test pH 5.5, but their lab lime requirements differ substantially. Should the same lime dose be used solely because their pH values match?

Answer: No. Use each soil's tested lime requirement and the selected product's characteristics.

Active pH does not measure all reserve acidity. Different buffering capacities can require different quantities to reach the same target.

Exam trap: Equal pH readings do not establish equal amendment requirements.

Standard reference: RSOS 2018 B-7.03.04P

What design term describes equal visual weight on opposite sides of a composition without mirror-image arrangements?

Answer: Asymmetrical balance.

Different forms or groupings can balance their visual weight without repeating the same shapes on both sides.

Exam trap: Symmetry specifically uses a mirrored arrangement; balance does not require it.

Standard reference: RSOS 2018 C-8.01.03L

A socketed drainage pipe rocks on its enlarged bell while its barrel bridges the prepared bedding. How should the bedding be corrected before assembly continues?

Answer: Make a bell recess while preserving continuous support beneath the barrel.

The enlarged socket needs clearance so the pipe bears along its barrel rather than rocking on the bell. Bedding must still support the pipe to its required line and grade.

Exam trap: Packing only under the bell increases the isolated bearing instead of supporting the barrel.

Standard reference: RSOS 2018 C-8.04.06P

Screed rails have been lifted out of an accepted paver bedding layer, leaving parallel channels. What must be done before pavers cover those channels?

Answer: Fill the channels with matching bedding material and strike them to the established plane.

Removing the guides leaves voids in the bedding. Restoring their level provides support beneath the pavers laid across them.

Exam trap: Bridging an empty rail channel with pavers leaves a line of inadequate support.

Standard reference: RSOS 2018 C-9.02.11P

A pond liner bridges the bottom corners during initial filling. Pulling the edges tight would remove the visible folds. How should the liner instead be fitted?

Answer: Feed slack into the corners so the liner conforms to the excavation as it fills.

Water loads a bridged liner and can pull on its edges or fittings. The liner should follow the supported shape instead of spanning corners under tension.

Exam trap: Stretching it tight to remove every fold can create unsupported, stressed areas.

Standard reference: RSOS 2018 C-9.05.05P

A container shrub has a dense ring of roots circling the pot wall. What root preparation is needed before it goes into the planting hole?

Answer: Loosen, redirect or appropriately cut the circling roots before planting.

Corrective root preparation interrupts the pot-bound pattern and encourages outward growth into the surrounding soil.

Exam trap: Leaving a tight root ring intact preserves the constricting growth pattern after the pot is removed.

Standard reference: RSOS 2018 C-10.02.02P

A turf-seed specification limits burial to 6 mm. A drill trial leaves seed 14 mm below the finished surface. What adjustment is required before seeding the lawn?

Answer: Set the drill shallower and verify a new trial meets the 6 mm limit.

Seed placement must match the required burial depth. Checking the actual result confirms the setting before the entire lawn receives seed too deeply.

Exam trap: Burying seed more deeply as drought protection can prevent satisfactory emergence.

Standard reference: RSOS 2018 C-10.05.04P

A rainwater cistern overflow is being completed beside a building. What must the outlet arrangement accomplish when the tank is full, apart from excluding insects?

Answer: Carry excess water safely to the approved discharge point without wetting the foundation.

A full cistern must pass incoming excess water through a suitably sized overflow route. Its destination and capacity matter as well as insect exclusion.

Exam trap: Ending the overflow beside the foundation relocates runoff to a vulnerable part of the building.

Standard reference: RSOS 2018 C-11.03.03P

A trial of acidic masonry cleaner dulls and roughens a limestone step even after the dirt is removed. What type of cleaner should replace it for the remaining limestone?

Answer: A compatible non-acidic stone cleaner, such as an approved neutral cleaner.

Limestone's carbonate minerals react with acid. The dull, rough trial surface indicates etching of the stone itself, so continuing with the acidic cleaner would remove or damage more of the finish.

Exam trap: Diluting the acidic product without establishing compatibility may slow the attack but does not make it suitable for limestone.

Standard reference: RSOS 2018 D-12.04.03P

Inspection confirms that a young tree is firmly rooted and no longer needs supplemental support. Its original stakes and ties remain. What maintenance prevents those supports from becoming a source of damage?

Answer: Remove the unneeded staking and guying materials.

Once adequate anchorage is confirmed, supports left in place can rub bark, restrict growth or girdle the stem. Removal addresses the changing support requirement as the tree establishes.

Exam trap: Leaving ties indefinitely for extra security can turn temporary support into a constricting attachment.

Standard reference: RSOS 2018 D-13.01.14P

A turf irrigation test collects an average depth of 5 mm in 10 minutes. At the same settings, how many minutes of total operation apply 18 mm, assuming a constant rate and no runoff?

Answer: 36 minutes of total operation.

The measured rate is 5 ÷ 10 = 0.5 mm/min. Applying 18 mm therefore takes 18 ÷ 0.5 = 36 minutes at the stated settings and conditions. This is the total operating time, whether delivered in one or several suitable cycles.

Exam trap: 18 minutes treats the measured application rate as 1 mm/min instead of 0.5 mm/min.

Standard reference: RSOS 2018 D-13.03.02P

Stored rainwater tests clean at the cistern, but contamination may be entering through an old irrigation hose. Where should the additional sample be taken to assess the water actually reaching the plants?

Answer: At the hose discharge, where the irrigation water reaches the plants.

A cistern sample describes water before it passes through the suspect hose. Sampling after that component tests the actual delivered water and can reveal contamination introduced downstream of storage.

Exam trap: Repeating only the cistern sample leaves the suspected downstream contamination outside the test.

Standard reference: RSOS 2018 D-14.02.05P

10 pairs · 1 decoyChecked at the end