Sign in
MathOnline Red Seal Exam Preparation, built on official standards
Tool and Die Maker math scenarios
MathQuestion 4 of 1070% to goContinue at question 4
10 questions
2 right · 1 wrong · 7 to do- 1Blanking force for a 50 mm disc
- 2Bend allowance with the C variable
- 3Die opening for a punched hole
- 4Micrometres in a thousandth of an inch
- 5A ±0.02 mm tolerance in inches
- 6Spindle speed for a 3/8 in carbide end mill
- 7Milling time for a 150 mm slot
- 8Press rating with a 30% allowance
- 9Parts from a strip in a progressive die
- 10What the C variable stands for
Part 1
2 right · 1 wrong · 7 to do- 1Blanking force for a 50 mm discCutting force = L × T × S · Procedural and application
- 2Bend allowance with the C variableBend allowance = (r + C) × (2π × angle ÷ 360) · Procedural and application
- 3Die opening for a punched holeDie opening = punch + 2 × clearance per side · Critical thinking
- 4Micrometres in a thousandth of an inchConversion · Knowledge and recall
- 5A ±0.02 mm tolerance in inchesConversion · Procedural and application
- 6Spindle speed for a 3/8 in carbide end millrpm (imperial) = 12 × CS ÷ (π × D) · Procedural and application
- 7Milling time for a 150 mm slotTime (mill) = L ÷ (fpt × N × rpm) · Procedural and application
- 8Press rating with a 30% allowancePress tonnage = force ÷ 9.81 × allowance · Critical thinking
- 9Parts from a strip in a progressive dieLayout · Procedural and application
- 10What the C variable stands forBend allowance · Knowledge and recall
By question type
- Procedural and application2 of 6 done
- Critical thinking1 of 2 done
- Knowledge and recall0 of 2 done