Sign in
MathOnline Red Seal Exam Preparation, built on official standards
Sprinkler Fitter math scenarios
MathQuestion 4 of 1070% to goContinue at question 4
10 questions
2 right · 1 wrong · 7 to do- 1Discharge from a standard sprinkler
- 2Pressure needed at the riser gauge
- 3Sprinkler spacing along a branch line
- 4The factor from psi to kilopascals
- 5Friction loss over pipe and fittings
- 6Cut length of a threaded pipe between tees
- 7Fire pump rating in gpm
- 8Hydrostatic test pressure on a metric gauge
- 945° offset around a duct in a branch line
- 10Water supply for the system and hose demand
Part 1
2 right · 1 wrong · 7 to do- 1Discharge from a standard sprinklerQ = K√P · Procedural and application
- 2Pressure needed at the riser gaugeElevation head 0.433 psi/ft · Procedural and application
- 3Sprinkler spacing along a branch lineArea per sprinkler · Critical thinking
- 4The factor from psi to kilopascalsConversion · Knowledge and recall
- 5Friction loss over pipe and fittingsFriction loss = equivalent length × loss per foot · Procedural and application
- 6Cut length of a threaded pipe between teesCut length = centre to centre − take-outs + thread make-up · Procedural and application
- 7Fire pump rating in gpmConversion · Procedural and application
- 8Hydrostatic test pressure on a metric gaugeConversion · Procedural and application
- 945° offset around a duct in a branch lineTravel = offset × 1.414 · Procedural and application
- 10Water supply for the system and hose demandVolume = flow × duration · Critical thinking
By question type
- Procedural and application2 of 7 done
- Critical thinking1 of 2 done
- Knowledge and recall0 of 1 done