Sign in
MathOnline Red Seal Exam Preparation, built on official standards
Metal Fabricator (Fitter) math scenarios
MathQuestion 4 of 1070% to goContinue at question 4
10 questions
2 right · 1 wrong · 7 to do- 1Angle of a brace from rise and run
- 2Stretch-out of a rolled cylinder
- 3Mass of a 12 mm plate before the lift
- 4The plate weight figure on a U.S. take-off
- 5Flat blank from a bend deduction
- 6Weld length on an intermittent seam
- 7A 620 kg frame on a lift gate rated in pounds
- 83/8 in plate in millimetres
- 9What GOSL on an angle detail means
- 10Diagonal for squaring a frame
Part 1
2 right · 1 wrong · 7 to do- 1Angle of a brace from rise and runDegrees = tan⁻¹(rise ÷ run) · Procedural and application
- 2Stretch-out of a rolled cylinderStretch-out = π × mean diameter · Procedural and application
- 3Mass of a 12 mm plate before the liftMass = volume × 7 850 kg/m³ · Critical thinking
- 4The plate weight figure on a U.S. take-offPlate weight per square foot · Knowledge and recall
- 5Flat blank from a bend deductionFlat length = sum of outside dimensions − bend deduction · Procedural and application
- 6Weld length on an intermittent seamWeld length = welds per side × weld length × sides · Procedural and application
- 7A 620 kg frame on a lift gate rated in poundsConversion · Procedural and application
- 83/8 in plate in millimetresConversion · Procedural and application
- 9What GOSL on an angle detail meansAcronym · Knowledge and recall
- 10Diagonal for squaring a framePythagorean theorem · Procedural and application
By question type
- Procedural and application2 of 7 done
- Critical thinking1 of 1 done
- Knowledge and recall0 of 2 done