Sign in
MathOnline Red Seal Exam Preparation, built on official standards
Machinist math scenarios
MathQuestion 4 of 1070% to goContinue at question 4
10 questions
2 right · 1 wrong · 7 to do- 1Spindle speed for a 12 mm end mill
- 2Table feed for a four-flute cutter
- 3Turning time with approach and overrun
- 4The constant for the best thread wire
- 5Tap drill for an M10 × 1.5 thread
- 6Measurement over wires for a 7/8-9 UNC thread
- 7A 1.2500 in bore in millimetres
- 8Gauge blocks for a 5 in sine bar at 12°
- 9Minor diameter of a 1/2-13 UNC external thread
- 10Cutting speed from a metric insert chart
Part 1
2 right · 1 wrong · 7 to do- 1Spindle speed for a 12 mm end millrpm (metric) = 1 000 × CS ÷ (π × D) · Procedural and application
- 2Table feed for a four-flute cutterFeed rate = fpt × N × rpm · Procedural and application
- 3Turning time with approach and overrunTime (lathe) = L ÷ (fpr × rpm) · Critical thinking
- 4The constant for the best thread wireWire size = 0.57735 × P · Knowledge and recall
- 5Tap drill for an M10 × 1.5 threadTap drill size = MD − P · Procedural and application
- 6Measurement over wires for a 7/8-9 UNC threadMeasurement over wires = MD + 3 × WD − 1.5155 ÷ tpi · Procedural and application
- 7A 1.2500 in bore in millimetresConversion · Procedural and application
- 8Gauge blocks for a 5 in sine bar at 12°Build-up = sine bar length × sin(angle) · Critical thinking
- 9Minor diameter of a 1/2-13 UNC external threadExternal thread depth = 0.6134 × P · Procedural and application
- 10Cutting speed from a metric insert chartConversion · Procedural and application
By question type
- Procedural and application2 of 7 done
- Critical thinking1 of 2 done
- Knowledge and recall0 of 1 done