Pass Your Red Seal
MathOnline Red Seal Exam Preparation, built on official standards
MathCalibration error, span and accuracyInstrumentationSee study access
All math

Calibration error, span and accuracy

Use the stated accuracy basis: span, upper range limit, reading or a combined specification are not interchangeable.

The formulas
  • Span = URV − LRV
  • Error = indicated − reference
  • Error (% span) = error / |span| × 100
  • Tolerance = specified % × |span| / 100
How to do it
  1. 1Record reference and indication at the same point.
  2. 2Calculate signed error, then compare absolute error with tolerance.
  3. 3Check several upscale/downscale points to distinguish offset, gain and hysteresis.
Worked example

A 0–400 kPa transmitter indicates 202 kPa at a 200 kPa reference. Error = +2 kPa = +0.5% of span. At ±0.25% of span tolerance (±1 kPa), it fails this point.

The usual mistakes
  • A correct digital PV with an incorrect loop signal points to a different part of the measurement chain than a sensor error.

Pass Your Red Seal’s lessons and practice are independent study material. Source: Yokogawa: square-root extraction

Try one

A −50 to 150 °C transmitter reads 51 °C at a 50 °C reference. What is the error as a percentage of span?

This topic

The lesson and a worked example
Practice questions in this topic12
Mixed practiceEvery math topic

Mixed practice

Every math topic

Keys this topic uses

  • ()Works the part in brackets first
  • ALPHA=Types ANS, the last answer

Calculator skill: order of operations

Topic practice2 questions · 0 done