Pass Your Red Seal
MathOnline Red Seal Exam Preparation, built on official standards
MathThread pitch, tap drills and measurement over wiresMachiningSee study access
All math

Thread pitch, tap drills and measurement over wires

P: axial pitch · w: wire diameter. These are basic 60° thread geometry relationships; final tolerances and tap-drill choice depend on the specified thread and material.

The formulas
  • Pitch(in) = 1/TPI
  • Approximate tap drill = major diameter − pitch
  • Metric pitch diameter ≈ major diameter − 0.6495P
  • 60° best wire diameter ≈ 0.57735P
  • Over wires = pitch diameter − 0.866025P + 3w
  • External depth ≈ 0.6134P; internal depth ≈ 0.5413P
How to do it
  1. 1Convert TPI to pitch for imperial work.
  2. 2Use matching units and distinguish major diameter, pitch diameter and actual wire size.
Worked example

For M10×1.5, the approximate drill is 10−1.5=8.5 mm. Best-size wires are 0.57735×1.5≈0.866 mm.

The usual mistakes
  • The 1.5155/TPI over-wire shortcut uses major diameter; do not substitute pitch diameter into that form.

Pass Your Red Seal’s lessons and practice are independent study material. Source: Red Seal: formula resources by trade

Try one

Using major diameter minus pitch, what approximate drill is used for M12×1.75?

This topic

The lesson and a worked example
Practice questions in this topic12
Mixed practiceEvery math topic

Mixed practice

Every math topic

Keys this topic uses

  • ()Works the part in brackets first
  • ALPHA=Types ANS, the last answer

Calculator skill: order of operations

Topic practice2 questions · 0 done