Pass Your Red Seal
MathOnline Red Seal Exam Preparation, built on official standards
MathFabrication layout and allowancesMachiningSee study access
All math

Fabrication layout and allowances

Use the units and definitions supplied by the drawing or exercise. Two protruding threads correspond to 2×pitch, not an unqualified 2 mm.

The formulas
  • Bolt length = grip + washers + nut thickness + specified protrusion
  • Tube expanded ID = initial ID + clearance + specified reduction allowance
  • Sheet exerciseV-opening = 10 × plate thickness
  • Drum capacity = (A+B)BCF (source-specific dimensions and factor)
How to do it
  1. 1Write an allowance stack with all dimensions in the same unit.
  2. 2Evaluate the stated factor model only after each variable and its units are known.
Worked example

With 40 mm grip, 4 mm washers, 10 mm nut and two 2 mm-pitch threads, required length=40+4+10+4=58 mm before choosing an available bolt.

The usual mistakes
  • Reference factors require the applicable tooling, rope or fastener specification.
  • Do not infer missing drum dimensions from the letters alone.

Pass Your Red Seal’s lessons and practice are independent study material. Source: Red Seal: formula resources by trade

Try one

A bolt stack has 30 mm grip, 3 mm washer, 8 mm nut and two 1.5 mm-pitch threads protruding. Find the calculated length.

This topic

The lesson and a worked example
Practice questions in this topic12
Mixed practiceEvery math topic

Mixed practice

Every math topic

Keys this topic uses

  • ()Works the part in brackets first
  • ALPHA=Types ANS, the last answer

Calculator skill: order of operations

Topic practice2 questions · 0 done